How RONBEN technology inspect the products

RONBEN technology is in strict compliance with industry standard inspection method and sampling standards, below you will see how we (RONBEN technology) inspect the finished products and how we do simpling.

AQL Sampling Table based on the Mil-STD-105D
Below is an example of how acceptance sampling method is used:

If the whole lot size is of 10, 000 units, using General Inspection level II, major 1.5 & minor 2.5 for inspection.

Acceptable Quality Levels for Normal Inspection (% defective)
Lot Size/Sample Size	.01	.015	.025	.04	.065	.10	.15	.25	.40	.65	1.0	1.5	2.5	4.0
	Lot Acceptance (Ac) Number (maximum number of rejects to accept the lot)
LS=2 to 8 SS=2	0	0	0	0	0	0	0	0	0	0	0	0	0	0
LS=9 to 15 SS=3	0	0	0	0	0	0	0	0	0	0	0	0	0	0
LS=16 to 25 SS=5	0	0	0	0	0	0	0	0	0	0	0	0	0	0
LS=26 to 50 SS=8	0	0	0	0	0	0	0	0	0	0	0	0	1	1
LS=51 to 90 SS=13	0	0	0	0	0	0	0	0	0	0	0	0	1	1
91 to 150 SS=20	0	0	0	0	0	0	0	0	0	0	0	0	1	2
151 to 280 SS=32	0	0	0	0	0	0	0	0	0	0	0	1	2	3
281 to 500 SS=50	0	0	0	0	0	0	0	0	0	0	1	2	3	4
501 to 1200 SS=80	0	0	0	0	0	0	0	0	0	1	2	3	5	7
1201 to 3.2K SS=125	0	0	0	0	0	0	0	0	1	2	3	5	7	10
3201 to 10K SS=200	0	0	0	0	0	0	1	1	2	3	5	7	10	14
10001-35K SS=315	0	0	0	0	0	0	1	2	3	5	7	10	14	21
35001-150K SS=500	0	0	0	1	1	1	2	3	5	7	10	14	21	-
150001-500K SS=800	0	0	0	1	1	2	3	5	7	10	14	21	21	-
	.01	.015	.025	.04	.065	.10	.15	.25	.40	.65	1.0	1.5	2.5	4.0

This means the sample size (ss) will be 200 units.

If the number of major defects found is less than 7, and minor defects is less than 10, then the shipment is passed under this inspection method.

Otherwise, if the major defects found exceed 7 and/or the minor defects found exceed 10, this shipment has to be rejected, under this inspection method.

P.S: All Inspection / 100% Inspection

Upon customer's request, we also provide 100% finish goods inspection, we shall the quality of each unit before shipment.

Prev: Whats the dead pixel?

Next: Most Important Considerations for Digital Frame Buyers